- HSRP group can contain more than two members; One is active member, one is standby router and the others will be in listening HSRP state.
- HSRP sends hello messages to 224.0.0.2 (All Routers Multicast Address) using UDP port 1985.
- HSRP group numbers can be [0,255]
- HSRP groups are locally significant on the interface. This is very important point to understand. For example, HSRP group 1 on the VLAN 10 interface is not same as the HSRP group 20 on VLAN 11 interface.
- HSRP router election:
Active Router is the one with the highest priority
If there is a priority tie then the router with the highest HSRP Ip address wins.
6. HSRP States: Disabled> Init> Listen> Speak> Standby> Active.
7. Only standby member monitors the hello messages. Listening members do not monitor them.
8. Default hello message every =3s; Hold time=10s
9. The actual interface address and the standby address must be configured to be in the same IP subnet.
9. The actual interface address and the standby address must be configured to be in the same IP subnet.
Form and manner of display of registration marks on the motor vehicles as per Central Motor Vehicles rulesAccording to sub-section (6) of section 41,on or after commencement of this rule, the registration mark referred to shall be displayed both at the front, rear and windshield of all vehicles clearly and legibly in the form of security license plate of the following specifications, namely.
ReplyDeletehsrp